ASME A112.18.6:2017 pdf free download

ASME A112.18.6:2017 pdf free download Flexible water connectors
1 Scope
1.1
This Standard covers flexible water connectors for use in water supply systems undera)continuous pressure in accessible locations; and
b) intermittent pressure in recreational vehicles only.
1.2
ln this Standard, ” shall” is used to express a requirement, i.e., a provision that the user is obliged tosatisfy in order to comply with the standard; “should” is used to express a recommendation or thatwhich is advised but not required; and “may” is used to express an option or that which is permissiblewithin the limits of the Standard.
Notes accompanying clauses do not include requirements or alternative requirements; the purpose of anote accompanying a clause is to separate from the text explanatory or informative material.
Notes to tables and figures are considered part of the table or figure and may be written asrequirements.
Annexes are designated normative (mandatory) or informative (non-mandatory) to define theirapplication.
1.3
Sl units are the units of record in Canada. ln this Standard, the yard/pound units are shown in
parentheses. The values stated in each measurement system are equivalent in application; however,each system is to be used independently.Combining values from the two measurement systems canresult in non-conformance with this Standard.
All references to gallons are to u.s. gallons.
For information on the conversion criteria used in this Standard, see Annex B.
2 Reference publications
This Standard refers to the following publications, and where such reference is made, it shall be to theedition listed below, including all amendments published thereto.
ASME(The American Society of Mechanical Engineers)
A112.19.5-2005
Trim for Water-closet Bowls, Tanks, and Urinals
B1.1-2003(R2008)
Unified Inch Screw Threads (UN and UNR Thread Form)
B1.20.1-1983 (R2006)
Pipe Threads, General Purpose, Inch
B1.20.3-1976 (R2003)
Dryseal Pipe Threads, Inch
B1.20.7-1991 (R2003)
Hose Coupling Screw Threads, Inch
B16.18-2001 (R2005)
Cast Copper Alloy Solder Joint Pressure Fittings
B16.22-2001 (R2005)
Wrought Copper and Copper Alloy Solder Joint Pressure Fittings
B16.26-2006
Cast Copper Alloy Fittings for Flared Copper Tubes
ASME (The American Society of Mechanical Engineers)/CSA Group
ASME A112.18.1-2012/CSA B125.1-12
Plumbing supply fittings
ASSE (American Society of Sanitary Engineering)/ASME (The American Society of Mechanical Engineers)/CSA Group
ASSE 1002-2015/ASME A112.1002-2015/CSA B125.12-15
Anti-siphon fill valves for water closet tanks
ASSE (American Society of Sanitary Engineering)
1061-2006
Performance Requirements for Removable and Non-Removable Push-Fit Fittings
ASTM International (American Society for Testing and Materials)
D6284-09
Standard Test Method for Rubber Property — Effect of Aqueous Solutions with Available Chlorine and Chloramine
ANSI (American National Standards Institute)/ISA (Instrumentation, Systems, and Automation Society)
75.02-1996
Control Valve Capacity Test Procedures
NSF International/ANSI (American National Standards Institute)
61-2015
Drinking Water System Components — Health Effects
NSF/ANSI 372-2016
Drinking Water System Components — Lead content